This error will automatically clear once the condition has been corrected.Ĭharge Timeout caused by battery pack not reaching required voltage within safe time limit. Check the battery voltage and cable connections. This error will automatically clear once the condition has been corrected.īattery Voltage is too low to start charge. If it fails again, do not continue to use the charger - replace the unit.īattery Voltage is too high to start charge. Remove AC and battery for minimum 30 MINUTES and retry charger. If persists, replace the unit.Ĭheck AUX DC connected to correct voltage battery (12V or 24V). Stackable and VCIM systems: Check connected chargers individually for faults.Ĭheck EVSE for proper operation. If it fails again, do not continue to use the charger - replace the unit.īattery Current Sense Circuit Rationality Remove AC and battery for minimum 30 seconds and retry charger. Troubleshooting and/or Recommended Actions pdf document version of the Delta-Q Fault and Error Codes List for IC/RC/ICL Series chargers. If this condition persists, replace the charger. If a unit is not functioning and nothing is indicated or logged, check and cycle both AC and DC. Not all will be displayed on chargers with a user interface. Most of these will be reported over CAN and logged. This article lists fault (F_ _ _ ) and error (E_ _ _ ) codes on these chargers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |